How ro change a finished document from two paqes into single pages

[Ann-Mari Hobert]

How do I change a finished dokument from double spread ( two pages next to each other) into a single page in the whole document. The printer wants this format.

[GarryP]

Welcome to the forums @Ann-Mari Hobert

If I have understood your requirements properly, you should be able to go into Document Setup, then the Model pane, and turn Facing Pages OFF – see attached image.

I would recommend doing this on a copy of the document, just in case something goes wrong.

Be careful to check that everything has been properly changed before sending it to the printer.

Alternatively, you can export the document as single pages by setting the area Area option in the Export Dialog from All Spreads to All Pages.

[walt.farrell]

3 hours ago, Ann-Mari Hobert said:

The printer wants this format.

As the printer probably wants a PDF, Garry's alternative answer is the one that usually applies best  

[Ann-Mari Hobert]

On 11/8/2024 at 2:37 PM, walt.farrell said:

As the printer probably wants a PDF, Garry's alternative answer is the one that usually applies best