Christopher A Posted April 5, 2021 Share Posted April 5, 2021 (edited) Sorry if this has been answered, but I couldn't find it. I am trying to make dotted lines that the dots are 1.5mm large and the spacing between them (*<-->* the distance between the *s here) are 6mm apart. But I'm not sure what the spacing should be set to. Any help? To try and clarify, i do not want it from inside one dot to the inside of another (middle, or otherwise). I want it from where one ends and the other begins. Edited April 5, 2021 by Christopher A Quote Link to comment Share on other sites More sharing options...
lepr Posted April 5, 2021 Share Posted April 5, 2021 Round caps Width 1.5 mm Dash 0 5 0 0 Old Bruce 1 Quote Link to comment Share on other sites More sharing options...
Christopher A Posted April 5, 2021 Author Share Posted April 5, 2021 I'm not using mm as the settings but inches. I am close not not 100% by using width at 4.3 and DASH 0 4.28 0 0 But it's not precise, and I need them as precise as possible Quote Link to comment Share on other sites More sharing options...
lepr Posted April 5, 2021 Share Posted April 5, 2021 Just now, Christopher A said: I'm not using mm as the settings but inches. I am close not not 100% by using width at 4.3 and DASH 0 4.28 0 0 But it's not precise, and I need them as precise as possible You'll get precisely 1.5 mm dots and 6 mm gaps if you enter the values I gave you. You can enter 1.5 mm into the width field regardless of your document units. Quote Link to comment Share on other sites More sharing options...
Christopher A Posted April 5, 2021 Author Share Posted April 5, 2021 11 minutes ago, anon2 said: You'll get precisely 1.5 mm dots and 6 mm gaps if you enter the values I gave you. You can enter 1.5 mm into the width field regardless of your document units. I did not know that - TY very much lepr 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.