Contour radius box should accept unrestricted values

[sfriedberg]

Using the tool, you can drag a contour an arbitrary distance from the original curve, and the radius box displays that value.  However, if you enter a value in the box, it truncates whatever you enter to the range [-50px..50px].  The radius box should accept any value you can generate interactively by dragging.

Not specific to the particular display field, it would be nice if you could set the desired display units (e.g., inches or mm rather than pixels).

[Added in edit]  When I say iteractively by dragging, I mean the contour tool itself on the page, not the slider you can open up under the radius box.

[Sean P]

Hi sfriedberg,

This is something that has been reported previously and only affects Windows. It has now been fixed by development and should make it into the next build.