Eddy-2 Posted October 23, 2019 Share Posted October 23, 2019 New to Photo. Add photo. Select Liquify persona. Select Mesh Clone Tool. Help file says Alt + Click to select, Photo says Click + Alt to select. I Click + Alt but get a fault message saying I should Click + Alt (which I've just done). I take the Help file's advice and use Alt + Click. I'm then advised to Drag or Hold to clone the mesh, but nothing happens. What am I missing? P.S. The other Liquify tools seem to work OK. Quote Link to comment Share on other sites More sharing options...
Staff DWright Posted October 23, 2019 Staff Share Posted October 23, 2019 Can you please check that the source clone location has a warp distortion otherwise the mesh that you clone will be normal and you will not see any changes Eddy-2 1 Quote Link to comment Share on other sites More sharing options...
Eddy-2 Posted October 23, 2019 Author Share Posted October 23, 2019 Thanks. If I understand you correctly, I'm not cloning part of the picture, as with the Clone Brush Tool - which I thought I was - but cloning a previous warped effect. Quote Link to comment Share on other sites More sharing options...
Staff DWright Posted October 23, 2019 Staff Share Posted October 23, 2019 That is correct it only clones the mesh grid. Eddy-2 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.