Search the Community
Showing results for tags 'afd-4203'.
-
Using the tool, you can drag a contour an arbitrary distance from the original curve, and the radius box displays that value. However, if you enter a value in the box, it truncates whatever you enter to the range [-50px..50px]. The radius box should accept any value you can generate interactively by dragging. Not specific to the particular display field, it would be nice if you could set the desired display units (e.g., inches or mm rather than pixels). [Added in edit] When I say iteractively by dragging, I mean the contour tool itself on the page, not the slider you can open up under the radius box.
-
Hello, I can’t enter anything above 50 px in the radius input box. The only way to successfully achieve a higher value is to grab an object’s handle (be it corner, or side, doesn’t really matter) and drag it left to decrease the value and right to increase it. Unfortunately there’s no cursor on my screenshot but that’s how I did it. Immediately after increasing the value via the input it resets to 50. The same for moving the pop-up slider. cheers Matt