Search the Community

Hi when transforming 3 objects which are rotated, the move tool / transform panel gives unexpected result. Steps to reproduce: create new document SVGA / RGB/8 Create a rectangular shape, with 400px, height 200px, color or gradient for pelasure Select anchor point middle of upper edge. move shape so anchor point is center of document (w/2, h/2) use power duplicate with 120° rotation select all 3 shapes Note: method (sequence) of selection can impact result, but no method produced correct result activate "Transform Objects Separately" State of "Cycle Selection Box" leads to different results, both unexpected. Try to increase width of all 3 shapes by numeric input 600 to transform panel in "w". Expected: all 3 shapes w changes. x,y, r, s, h stay constant Observed: shapes get transformed, unwanted change of x,y, r, s, h. Distortion based on single layer who was added last to selection, ignoring rotation and anchor point of other shapes. Note to readers: I can get the desired result by changing the shapes individually. This gets laborious in case of 2° rotation and 180 shapes to change. There might be other and better ways to get the expected result shape. The shapes are only to illustrate the issue. I don't need the result shown here, or workarounds. My intention is to get a generic solution (bugfix, workaround if possible) to change large numbers of shapes which are rotated, considering the individual rotation and the global selected anchor point in transform panel, to avoid re-creating the shape again with power duplicate. In some cases i can find the required w/h values only after power-duplicate. 1. Before 2. Observed: 3. Expected: 4. Document to reproduce: transform seperately.afphoto

>> just moving here...