cptnftr

Solved! Had to unplug it once! :wacko: Think it was a bit to early in the morning for such a complicated job...

Hello people, some (perhaps stupid) question again. I use the apple keyboard with numeric keypad. It seems that the shortcuts do not work. Is there some method to use it? Greetings from Berlin :)

Arrgh!

Hello people, at first i have to offer an excuse because of my bad English. I hope it is god enough for you to understand my question right. Since days i try to do some polyart stuff. Quite simple actually and always the same steps. Beginning with one triangle i try to link another one to the first by using a node for one or more triangles connected to the original node. Thats all but it does not work. It is extremely difficult to auto catch the nodes (with activated magnetic mode). Even if i only work with the raster restriction. If i combine the triangles to one plane to check if there are still errors (nodes not exactely on the SAME position of each other). This is superstrange and stressfull. Another disturbing thing. If i finally have a few correctly positioned triangles (after hours of work) and i copy and paste them to accelerate my work, there are errors in the copy but not in the original "mesh". Checked both, original and copy, by combining. Original becomes one plane with no errors, the copy have different of them. I attached some pictures of it. Left side the original and right side the copied on, before and after combining them) Super frustrating especially because i really like affinity´s software and definitively want to change from ai. Perhaps some solution? :( Greetings from Berlin

Thanks for your advice. I will try it. :)

Hello community, thanks for the possibility to take part here. Trying to figure out how "selecting by colour" works, i am not able to find the solution. Does anybody perhaps know how to do it? Similar to the Illustrator function "Select ... same colour". It would b nice if someone could help. Greetings from Berlin :)