DHust

Bummer. Thanks for the info. That's what I bought this program for. Guess I need to get a refund so I can buy Bookletcreator.

Let's retry this. Anyone know how to print a 16-page signature from a range of pages? I need to print about 10 of these 16-page signatures and then put them all together to make a book.

That doesn't work for booklets.

I think I misspoke when I said 4-page signature. What I meant was 4 pieces of paper which, I think, ends up being a 16-page signature. Unfortunately, book mode does not put them in the correct order. Any other ideas?

I'm trying to print 4-page signatures and then put them together in a textblock/booklet. I have about 180 pages to print so I need to only print a few at a time so that when I fold them it's not all messed up because I'm folding too many. Is there a way to only print 4 pages at a time in booklet mode? I've tried changing the range to print 1-4 but it still prints the second and second-to-last pages together. So it's basically determining the spread based off of the fact that I chose booklet and then after that it takes into consideration the pages I want to print. It needs to be the other way around for what I would like to do. Ideas?

The document I sent to you had the pages transformed so they worked for the booklet setting. I tried the n-up setup but it didn't print like a booklet. Page 3 ended up being blank. I think I have it figured out. I changed the paper type to Defined by Driver instead of A4. I think I'm using standard letter paper. The only thing about that is it tells me I'm going outside the printing area since I had it set to A5 paper initially. It prints fine so I'll just have to mess with that a bit further. Thanks for your time.

Done. Thanks for looking at it.

I've printed a booklet but noticed that the front page has different margins than the rest of the pages. Not only that but the odd pages have a different margin than the even pages. It's almost like the pages are moved to the left. I was able to get a few pages to look like it's supposed to by using Transform, but I shouldn't have to. When I look at the print preview it looks great. When it prints, it does not. Any ideas on how to fix this? Thanks